Selecting NIC for the traffic capture is a very important step in the TrafMeter Service configuration. A dialog for selecting the network adapters is available when you are connected to TrafMeter Service and when the capture status is not "In capture".

Changing selection of the network interfaces is possible when the capture status is not "In capture". Before selecting the network interfaces, you should Stop Capture and then Start Capture again.

 Note

• You are allowed to select several network adapters simultaneously for the traffic capture.
• If this computer acts as a gateway, you must select Active Mode.
• For better performance, don't select the network adapters whose the traffic will not be accounted.
• The network adapter may have several IP addresses, but you will see only one IP address in the network adapters selection dialog.
• Some network adapters based on the RTL8139 chip can be displayed as "NDIS 5.0". This is a normal behavior.

See details about Capture Modes